Shipping Instructions

Read the following sections carefully to ensure compliance with the requirements and recommendations for returning products or components, whether for credit, replacement, or repairs.

Returned Material Authorization (RMA) Number
Equipment may not be returned, whether for warranty or other purposes, without prior authorization and issuance by Fusion UV Systems of a Returned Material Authorization Number. Equipment returned for credit may be subject to a handling and restocking charge. Returned equipment must be shipped prepaid.

General Packing Instructions
If possible, original packaging materials should be reused for return shipment to Fusion UV Systems. You may order packaging materials by calling Fusion UV at 301-527-2660.  If Fusion UV Systems packaging materials are not used, equivalent packaging, as outlined in the following sections, is to be used.

Power Supply
Power supplies should be returned in their original packaging. If this is not available, the power supply should be packaged as follows:

Secure the chassis to the cover using ten M5 x 8 mm screws.

Box: Bursting Test:	24 kg/cm2 (350 lbs./sq. in.)
Gross Weight Limit:	46 kg (100 lbs.)

Fills:

Rigid high density styrofoam or cardboard fills as required to ensure power supply does not shift in box during shipment.

IMPORTANT NOTE:

Packaging materials should not push against connectors or controls.

Irradiators
Irradiators should be returned in their original packaging. If this is not available, lamps must be double boxed, as follows:

The lamp is to be placed in an inner box, using cardboard fills to assure a snug fit. The RF screen should be protected by taping a piece of cardboard over it. The inner box should then be placed in an outer box that provides about a two-inch clearance on all sides. High density styrofoam corner pads should be placed in the corners between the outer and inner boxes to isolate the lamp from impact.

Box: Bursting test:	24 kg/cm2 (350 lbs./sq. in.)
Gross Weight Limit:	20 kg (45 lbs.)

Magnetrons
Magnetrons must be double boxed as described below. Wrap magnetrons in three layers of plastic "bubble wrap" or equivalent. Place magnetrons in the box and add loose styrofoam fill. Place this inner box in an outer box and surround the inner box with loose styrofoam fill.

UV Bulbs
Place the bulb in a rigid tube (use Fusion UV Systems original plastic shipping tube, if available.) Secure ends to prevent impact against the tube and wrap the tube in three layers of plastic "bubble wrap" or equivalent. Ship with loose styrofoam fill in the box.

Control Cards
The integrated circuits in control board assemblies are susceptible to damage from static electrical charges which may be transmitted by handling or packaging materials. To guard against static, place control cards in anti-static bags, if available. If not, wrap control cards in aluminum foil. Isolate the cards from impact with additional wrapping of "bubble wrap" or equivalent.

RF Detectors
RF Detectors should be wrapped in two layers of "bubble wrap" or equivalent and placed in a box with loose styrofoam fill.

Optional Controller
The LHC10 Controller should be returned in their original packaging. If this is not available, the controller should be packaged as follows:

Box: Bursting Test:	24 kg/cm2 (350 lbs./sq. in.)
Gross Weight Limit:	11 kg (25 lbs.)

Fills:

Rigid high density styrofoam or cardboard fills as required to ensure controller does not shift in box during shipment

IMPORTANT NOTE:

Packaging materials should not push against connectors or controls.